LCR-T3 Transistor Tester Diode Triode Capacitance ESR LCR Meter MOS PNP NPN

Description

LCR-T3 Transistor Tester Diode Triode Capacitance ESR LCR Meter MOS PNP NPN
Description:
LCR-T3 graphical multi-function tester resistor capacitor + + + SCR + diode + transistor + mos tube inductance
LCD 12864 LCD display, with backlight , backlight color is generally yellow-green .
9v battery powering stacked . If prolonged power , you can use two 8.4v lithium battery
Function:
1.Add boot voltage detection function
2.Automatic detection of NPN and PNP transistors , N -channel and P-channel MOSFET, diodes ( including dual diode ) , thyristors , transistors, resistors and capacitors and other components ,
3.Automatic test out the pin element and displayed on the LCD
4.Can be detected to determine the transistor emitter forward bias voltage of the transistor , MOSFET protection diode and the amplification factor of the base
5.Measure the gate threshold voltage and gate capacitance of the MOSFET
6.1602 lcd display uses LCD (12864 LCD with backlight )
7.High test speed , valid component test: 2 seconds ( except in the larger capacitor of large capacitance measurement also takes a long time , the measured time of one minute is normal )
8.One button operation , power-on test , get a key .
9.Power consumption off mode : less than 20 nA of
10.Auto power off function to avoid unnecessary waste , saving battery power , improved battery life.
Test ranges:
Inductors, capacitors , diodes, dual diode , mos, transistor, SCR , the regulator, LED tube , ESR,
Resistance,Adjustable potentiometer
Resistance :0.1 ohm resolution, maximum 50M ohm
Capacitor :25pf -100,000 uf
Inductors : 0.01mh-20H
NEW Function:
1:Automatic detection of NPN and PNP transistors, n-channel and p-channel MOSFET, diode (including double diode), thyristor, transistor, resistor and capacitor and other components
2: Automatic test the pin of a component, and display on the LCD
3:Can detect the transistor, MOSFET protection diode amplification coefficient and the base to determine the emitter transistor forward biased voltage
4: Measure the gate and gate capacitance of the MOSFET threshold voltage
5:Use 12864 liquid crystal display with green backlight
Specifications: For you reference
1.One -button operation, automatic shutdown .
2.Only 20nA shutdown current.
3.Automatically detect NPN, PNP bipolar transistors , N -channel and P -channel MOS FET, JFET , diodes , two diodes, thyristors small power unidirectional and bidirectional thyristor.
4.Automatic identification components pin arrangement .
5.Measuring bipolar transistor current amplification factor and base - emitter threshold voltage.
6.Via the base - emitter threshold voltage and high current amplification factor to identify Darlington transistors.
7.Can detect bipolar transistors and MOS transistors protection diodes.
8.Measuring the gate MOS FET threshold voltage and the gate capacitance.
9.Can simultaneously measure two resistors and resistor symbol is displayed. Displayed on the right with a decimal value of 4 . Resistance symbol on both sides shows the pin number. So you can measure the potentiometer. If the potentiometer wiper is not transferred to an extreme position , we can distinguish the middle and both ends of the pin.
10.Resistance measurement resolution is 0.1 ohms , 50M ohms can be measured .
11.Can measure capacitanceCan measure capacitance of 30pF-100mF , resolution 1pF.
12.2uF more capacitors can simultaneously measure the equivalent series resistance ESR values. The two can be displayed with a decimal value , resolution 0.01 ohms.
13.Can be in the correct order and the diode symbol display two diodes , and gives the diode forward voltage.
14.LED is detected as a diode forward voltage higher . Combo of the LED is identified as two diodes.
15.Eeverse breakdown voltage is less than 4.5V Zener diode can be identified.
16.Can measure a single diode reverse capacitance. If the bipolar transistor connected to the base and collector or emitter of a pin , it can measure the collector or emitter junction reverse capacitance .
17 can be obtained with a single measurement rectifier bridge connection.
Notice: Before measuring capacitance , the capacitor must be discharged , otherwise very likely damage the meter .
Package:
1 x HQ-LCR-T3
Shipping Notice
Country
Shipping time by
Registered Air Mail
or
E-packet
delivery
Shipping time by
FedEx/DHL/EMS
United States
5-15 business days
3-7 business days
Japan, South Korea
5-20 business days
3-7 business days
United Kingdom,Canada, Germany, Austria, Holland, Czech, EU
15-25 business days
4-7 business days
Spain, Russia, Italy, France, Mexico, Indonesia, Malaysia, India, South Africa, American & Asian countries
15-55 business days
5-15 business days
Case & Return
Please don't easily open an ebay/paypal case or return, do ctc us and tell what's the
problem, we will try to solve any problems and cover your rights.Thanks!
Payment Method
Paypal Only
Shipping Method
1.
We ship to
USA by e-packet
delivery shipping method,t
o
other country by registered China Post Air Mail
, to most of countries, it takes 10-20 business days to arrive if no shipping delay is incured. but to some remote
countries,such as South America, Africa and East Aian countries, it may take longer time 40-60 days,so please be patient to wait.
2.If you need items urgently please paid for expedit shipping fee,then we will ship by fast shipping way such as Fedex, DHL, Aramex and EMS.
Please send us message to indicate a shipping way as your special requirment
.Or we will choose shipping way for you randomly.
Feedback & DSR
Please place positive feedback and give high DSR score to us if you are satisfied with our quality of our products and our quality of our service, if you are not happy with your purchase for any reason, please ctc us first for solutions. We solve all your problems and we cover all your rights. Thanks for your support!
On Aug-07-19 at 15:39:05 PDT, seller added the following information: